Najdi zedníka
Home / Drywall and partitions

Drywall and partitions

Drywall and a masonry partition block solve the same task in two different ways. Board on steel studs is fast, light and hides services inside it; a masonry partition is heavier, harder to change, but carries load better and behaves differently with sound. The decision makes sense based on what will hang on that wall and what is next to it, not on which is cheaper at the moment.

A craftsman sanding the joints of a drywall ceiling

When drywall and when a masonry block

AspectDrywallMasonry partition
Speed and dustFast to build, dust mainly from sanding jointsLonger process, laying then plastering, more wet work
Fixing heavy itemsOnly into prepared noggings or special anchorsCarries load almost anywhere on the surface
SoundDepends on build-up, insulation and layers, wide rangeSet by the mass of the masonry, harder to change later
Services insideRun in the cavity without chasingA chase has to be cut
Changing it laterComes apart relatively cleanlyMeans demolition and debris

The most common mistake is to decide on price and only then discover that a wall unit or a television is meant to go on that partition. Fixings can be solved in drywall, but they have to be planned in advance, while the frame is going up. Afterwards it means opening a finished wall.

Sound between rooms

With a drywall partition it is not the board alone that decides but the whole build-up: the thickness and type of stud, insulation in the cavity, the number of boards on each side, the junctions with floor and ceiling and whether an uninterrupted air path runs through the cavity. Two partitions from the same material can therefore behave entirely differently. If you are separating a bedroom from a living room or building a wall against a neighbour, say so up front; the build-up is adjusted for it.

In a masonry partition the mass does the work. A partition block has the advantage that sound passes through it less readily on its own, but the junctions with the ceiling and side walls matter just as much as in drywall. A gap running the full length cancels much of what the wall can do.

Suspended ceilings and service walls

A suspended ceiling is built for services, lighting or to lower a tall room. Two things apply: anything that is to be fixed to it needs a nogging prepared in advance, and everything left above it will later be reachable only through an access panel. A service wall is the same thing stood up: it hides waste pipes, a riser or a cistern and lets cabling run without chasing into a load-bearing wall.

What has to be settled first

  • The layout, including where the doors go and how wide they should be.
  • Knowing what will hang on the wall, so noggings can be fitted.
  • Demolition and clearing finished. A partition is built into an empty space, not among leftovers.
  • Service routes thought through, so the cavity is used and nothing is chased needlessly.

Settling these things on site usually costs more than an hour of thinking beforehand. What follows is covered under plaster and stucco, and if taking out an old partition is also in play, carry on to demolition and brickwork.

Other masonry work

Send your job description

Frequently asked questions

What will a drywall partition carry?

It depends on what is inside it. An ordinary board takes only light items on special anchors. For a television, wall units or a basin, a nogging or a load-bearing panel is fitted while the frame is built, and the wall then carries considerably more. That is why it has to be said before the partition is closed up.

Is a masonry partition better for sound than drywall?

Not automatically. A masonry partition works through mass, drywall through its build-up. A well designed drywall partition with insulation and double boarding can perform better than a thin masonry one. What decides is the detailing, above all the junctions with ceiling and floor.

Can drywall be used in a bathroom?

Bathrooms use boards made for damp conditions, and a waterproof membrane is applied under the tiling. Without it moisture gets into the joints and the structure suffers in time. The choice of board and of waterproofing belongs in the brief, not in the last minute.

Describe the job

No drawings or exact square metres needed. Write what should be done, what condition it is in now and when you would like it finished. We will ask about the rest.

  • We pass the enquiry to a firm that does masonry work in your area.
  • If we have no partner in your area, we say so straight away instead of leaving you waiting.
  • Photos of the current state help the most. You can send them to info@najdi-zednika.cz.

775 654 443
info@najdi-zednika.cz