Six sentences that decide it
- What needs doing. Specifically: hack off and replaster, re-skim, build a partition, make good after the electrician.
- What condition it is in now. True or crooked walls, sound or hollow plaster, damp patches, before or after demolition.
- How much of it there is. It need not be exact. Number of rooms, rough area, ceiling height.
- What the access is like. Floor, lift, parking, restrictions in the building, quiet hours.
- Who supplies the material and whether the firm is to arrange debris removal.
- When it should happen and whether the flat will be lived in during the work.
Photos do more than a paragraph
Two photos of each room: one general and one close up. The general one shows the scope and how broken up the space is, the close-up shows the state of the surface. If there is a wall you are unsure about, photograph it from the side so the light rakes across it. How true it is shows better in such a photo than in any description.
For demolition, add a photo of the wall from both sides and say whether you know what is load-bearing. If you do not know, say that too; it is a better input than an assumption.
A template you can use
Hello, I need two rooms re-skimmed in a flat in a panel building, roughly the scope of a smaller flat in total. The walls have had wallpaper removed and the plaster is hollow in places. The flat is on the third floor, there is a lift, parking outside is difficult. I would leave the material to you, including debris removal. The flat is lived in, so I need the work done in stages. Timing ideally around the turn of the month, but it is not critical. Photos of the walls from the side and close up are attached.
A brief like this can be priced without three rounds of questions. More importantly, it can be sent to several firms in identical wording, so the quotes that come back are comparable.
What to avoid in an enquiry
- Asking only for a rate per metre. You will get an answer, but it will apply to someone else's flat.
- Writing "something small". What is small for you may not be small to carry out, and the other way round.
- Hiding a poor substrate. It comes out at the first site visit and only causes delay.
- Sending different briefs to different firms. The quotes then cannot be compared.
What affects the price is summed up on What drives the price. Which way of charging to choose is covered in the article on hourly rates and prices per metre.
More articles
Describe the job
No drawings or exact square metres needed. Write what should be done, what condition it is in now and when you would like it finished. We will ask about the rest.
- We pass the enquiry to a firm that does masonry work in your area.
- If we have no partner in your area, we say so straight away instead of leaving you waiting.
- Photos of the current state help the most. You can send them to info@najdi-zednika.cz.